Loading Media into Tray 1
Tray 1 (multi-purpose) holds up to
100 sheets of paper or up to
10 envelopes.
1
Open Tray 1 by pulling the front
cover down.
2
Slide out the plastic tray extender.
If the media being loaded is longer
than 229 mm (9 in.), also flip open
the additional tray extender.
3
Slide the paper width guides slightly
wider than the media.
4
Place media into the tray (short-
edge in, print-side up). The media
should be centered between the
paper width guides and under the
tabs on the paper width guides.
5
Slide the paper width guides inward
until they lightly touch the media
stack on both sides without bending
it. Make sure the media fits under
the tabs on the paper width guides.
Note
Do not add media to Tray 1 while the
printer is printing. This could cause a
paper jam. Do not close the front door
when the printer is printing.
For preprinted material, see Printing on
Letterhead or Preprinted Forms.
For envelopes or labels, see Printing on
Envelopes or Printing on Labels.
1
2
3
4
5
ENWW
Chapter 2 Printing Tasks 37